®
After the initial parameters were determined by our Process Boundary Analysis® techinique, our design team began to break the design down into smaller parts so each design sub-team could focus on the different aspects of the device. Teams were assigned to handle human interface components, device containment structure, signal transmission conduits, etc. But the real heart of the device was assigned to the senior members of the design team: The Borbely Tube Control Grid. Here lay the very brains of the device. Yes, the Borbely Tube Control Grid was going to make or break this entire concept. Again, here is an early design document showing the integretion of the Borbely Tube with the MOSFET Op Amps to produce the control grid. The only questions were:

1) Could the Borbely Tube footprint be squeezed into a reasonably-sized control device and 2) could mass production bring down the per-unit cost of the Borbely Tubes to be used?

continue tour >>

nakedwhiz.com       Home       Search Our Site       Email The Whiz       Listen To Whizcast       Whizlog       Buy Whiz Gear       Privacy Policy      
All Contents ©2001, 2023 The Naked Whiz
International Association of Fire Safety Science member #1604

You can support this website by shopping at The Naked Whiz Website Store and Amazon.com

You can make donations to The Naked Whiz
Website using Bitcoin! Scan the QR code at
left or copy and paste our wallet ID:

1Bt4vjU9PUQNVvEZZq6ik6jWYr6nr4rJRp